Huawei WDR814IG, WDR814G user manual Troubleshooting, Hardware

Aolynk WDR814(I)g ADSL2+ Wireless Router User Manual 6 Troubleshooting

5 Troubleshooting

This chapter provides solutions to problems you may encounter during installation and operation of your ADSL Wireless Router.

Hardware

Q: The Power LED is off.

Check that the power cable is properly connected to the ADSL Wireless Router, the power adapter and the socket.

Q: The LAN Link LED is off.

Check that the computer, hub or switch is properly connected to the ADSL Wireless Router.

Check that the computer’s Ethernet card is properly installed.

Check that the ADSL Wireless Router and the computer are on the same network segment. If you are not sure, initiate the DHCP function (4-1) and set your computer to obtain an IP address automatically (3-3).

Check that the computer is using an IP address in the range of 192.168.1.2 ~ 192.168.1.254 and is therefore compatible with the ADSL Wireless Router’s default IP address of 192.168.1.1 (3-3). Check also the Subnet Mask is set to 255.255.255.0

Q: The DIAG LED stays lit.

The DIAG LED should light up when the device is first powered up to indicate it is checking for proper operation. After a few seconds, the LED should go off. If it stays lit, the device is experiencing a problem. Please contact your dealer.

Q: Why can’t I configure the ADSL Wireless Router?

First, check whether the ADSL Wireless Router is properly installed or not, including the LAN and WAN connections, and that all devices are switched on.

Next, check the IP configuration of your PC:

nFor Windows 95/98 users: Run winipcfg.exe or winipcfg from Run on the Start menu. If there are no IP addresses shown, click Release All and then click Renew All to get the IP addresses.

nFor Windows NT 4.0 users: run ipconfig.exe or ipconfig from Run on the Start

50