Hawking Technology HWUG1A manual How to Change Your IP Address to Static mode

Page 10

How to Change Your IP Address to Static mode

-If your wireless network uses a static IP address or requires manual configuration you may do so by highlighting the USB wireless adapter(Shown above).

-Select “Configure” to enter the configuration menu for the wireless adapter.

-Select the Tab that is named TCP/IP

-Select the menu button for “Configure IPv4” and choose the appropriate selection

-You manually configure your IP Address, DNS Servers and other information here.

-Please contact a network administrator if you are uncertain of the settings that are required to connect to your network.

-When you have finished select APPLY NOW to continue.

7

Image 10

Contents Page Hawking Limited Warranty Contents Specifications FeaturesIntroduction Package Contents Installation Procedure Page If You Have a Previously Installed Airport Card Page How to Change Your IP Address to Static mode Configuration Utility Site SurveyProfile Including Profile Name, SSID, Channel, etcActive mode Power Saving ModeCAMConstantly Awake Mode The card will always set When it is idleThrough an Access Point or Router. Peer to Peer Ad-Hoc- Select this mode if you want to connect to anotherWireless station in the Wireless LAN network without going Mode depending on the wireless stations which the card isWPA-PSK-It is a special mode designed for home and small Parameter Description Authentication TypeIdentified are allowed to connecting each other Users that dont have the matching password from joining01234567890123456789abcdef or administrator Wireless networkWireless stations in the network Tkip Tkip Temporal Key Integrity Protocol changesFor the networking Link StatusThis check box Device for quality network operation Statistics Advanced About Troubleshooting What is TKIP? What is BSS ID？What is WEP？ What is AES?What is Spread Spectrum？ What is Hi-Gain and dBi?