Hawking Technology HWUG1A Parameter Description Network Type, Point or Router, List, Recommended

Page 14

Parameter

Description

Network Type

Infrastructure – This operation mode requires the presence of an

 

802.11 Access Point. All communication is done via the Access

 

Point or Router.

 

Ad-Hoc– Select this mode if you want to connect to another

 

wireless station in the Wireless LAN network without going

 

through an Access Point or Router. Peer to Peer.

Transmit Power

If you wish to lower the transmit power of the card to save the

 

power of your system, you can select the lower percentages from

 

the list.

11B Preamble Type

The preamble defines the length of the CRC block for

 

communication among wireless stations. This option is only active

 

in the Ad Hoc network.

 

There are two modes including Auto and Long Preamble. If

 

“Auto“ mode is selected, the card will auto switch the preamble

 

mode depending on the wireless stations which the card is

 

connecting to.

RTS Threshold

Minimum packet size required for an RTS (Request To Send). For

 

packets smaller than this threshold, an RTS is not sent and the

 

packet is transmitted directly to the wireless network. Select a

 

setting within a range of 0 to 2312 bytes. Minor change is

 

recommended.

Fragment Threshold

The value defines the maximum size of packets; any packet size

 

larger than the value will be fragmented. If you have decreased

 

this value and experience high packet error rates, you can

 

increase it again, but it will likely decrease overall network

 

performance. Select a setting within a range of 256 to 2312 bytes.

 

Minor change is recommended.

Channel

This setting is only available for Ad Hoc mode. Select the number

 

of the radio channel used for the networking. The channel setting

 

should be the same with the network you are connecting to.

11

Image 14
Contents Page Hawking Limited Warranty Contents Introduction FeaturesSpecifications Package Contents Installation Procedure Page If You Have a Previously Installed Airport Card Page How to Change Your IP Address to Static mode Configuration Utility Site SurveyProfile Including Profile Name, SSID, Channel, etcActive mode Power Saving ModeCAMConstantly Awake Mode The card will always set When it is idleThrough an Access Point or Router. Peer to Peer Ad-Hoc- Select this mode if you want to connect to anotherWireless station in the Wireless LAN network without going Mode depending on the wireless stations which the card isWPA-PSK-It is a special mode designed for home and small Parameter Description Authentication TypeIdentified are allowed to connecting each other Users that dont have the matching password from joining01234567890123456789abcdef or administrator Wireless networkWireless stations in the network Tkip Tkip Temporal Key Integrity Protocol changesThis check box Link StatusFor the networking Device for quality network operation Statistics Advanced About Troubleshooting What is TKIP? What is BSS ID?What is WEP? What is AES?What is Spread Spectrum? What is Hi-Gain and dBi?