GarrettCom P62F manual Connecting Fiber Optic SC-type, Snap-In, Connecting Single-Mode Fiber Optic

1.Using standard twisted pair media, insert either end of the cable with a RJ-45 plug into the RJ-45 connector of the port. Note that, even though the connector is shielded, either unshielded or shielded cables and wiring may be used.

2.Connect the other end of the cable to the corresponding device.

3.Use the LINK LED to ensure proper connectivity by noting that the LED will be illuminated when the unit is powered and proper connection is established. If this does not help, ensure that the cable is connected properly and that the device on the other end is powered and is not defective.

4.For Port # 1 or 1SW, if the LINK LED is not illuminated, move the switch which has a cross-over or up-link for linking to another hub or Switch.

3.2.2Connecting Fiber Optic SC-type, "Snap-In"

The following procedure applies to installations using SC-type fiber connectors. This procedure applies to ports using multi-mode SC fiber connectors.

1.Before connecting the fiber optic cable, remove the protective dust cap / plug from the end of the fiber connectors, exposing the ports opening. Save the dust cover / plug for future use, in case the fiber cable needs to be unplugged for service.

2.Wipe clean the ends of the dual connectors with a soft cloth or lint-free lens tissue dampened in alcohol. Make certain the connectors are clean before connecting. Then, insert the square male connector into the SC female jack of the Fiber port connector until it clicks and secures.

Note: One strand of the duplex fiber optic cable may be coded using color bands at regular intervals; you should use the color-coded strand on the associated ports at each end of the fiber optic cable segment.

3.Connect the Transmit (TX) port on the Magnum Fiber port to the Receive (RX) port of the remote device. Begin with the color-coded strand of the cable for this first TX-to-RX connection. Note – the two male square-end SC cable strands may be fastened together to plug as a unit.

4.Connect the Receive (RX) port to the Transmit (TX) port of the remote device. Use the non-color coded fiber strand for this.

5.The LINK LED for the fiber connector will illuminate when a proper connection has been established at both ends (and when power is ON in the unit). If LINK is not lit after cable connection, the normal cause is improper cable polarity. Swap the fiber cables at the fiber connector to remedy this situation.

3.2.3Connecting Fiber Optic ST-type, “Snap-In” (Optional)

The following procedure applies to installations using ST-type fiber connectors, i.e., using multi-mode ST.

When connecting fiber media to ST connectors, simply twist on the two round male connectors into the ST female jacks of the Fiber connector until it clicks and secures.

3.2.4Connecting Single-Mode Fiber Optic

When using single-mode fiber cable, be sure to use single-mode fiber port connectors.

Single-mode fiber cable has a smaller diameter than multi-mode fiber cable (9/125 microns for single-mode, 50/125 or 62.5/125 microns for multi-mode where xx/xx are the diameters of the core and the core plus the cladding respectively). Single-mode fiber allows full bandwidth at

www . GarrettCom . com

22