GarrettCom Magnum ST80 manual Twisted Pair Segment Connections, AUI Connection

Proper attachment of ST80s with

stacking/mounting bracket

Stackable Personal Hubs Installation and User Guide (04/01)

included in the stack, attach them in the same manner. (The brackets and screws included with the bottom unit of the stack will not be used for stacking purposes.)

3.4 Twisted Pair Segment Connections

1. Using standard 10BASE-T media, insert the male plug on one end of the network cable into one of the RJ-45 female ports on the Stackable Personal Hub. Even though the hub's

ports are of the shielded type, they will accept and operate properly with both shielded and unshielded type RJ-45 twisted pair wiring.

2.Connect the other end of

each wiring cable to the applicable workstation or user device. The port’s LINK LED illuminates when the connection is made on both ends of the wire, and when the DC power is on at each end, i.e., when the segment circuit is established and is ready to use.

		RI				PWR				AUI
		1B
		RI	Magnum ST80 Stackable Personal Hub
		2B
		O
	FF tS
O	En	ack	Ports 1 2	3 4	5 6		7	8	UP-LINK
N ab
el

RJ-45 User Connections

3.For the port 8 up-link feature, see 3.8.

3.5AUI Connection

Using the steps below as a guide, attach a new or existing 10BASE5 ThickNet drop-

cable directly to the AUI connector on the rear of the ST80 Personal Hub.

1.Plug the male end of the cable into the female AUI connector on the ST80.

2.Engage the AUI connector slide lock to insure maximum connectivity.

3.Connect the opposite end of the cable into a network AUI port. (This could be a network backbone transceiver, a hub or fan-out with an AUI port, or an AUI Port Module in a concentrator.)

www . GarrettCom . com

13