Fortinet manual FortiGate-5001FA2 normal operating LEDs

Inserting a FortiGate-5001FA2 board into a chassis Hardware installation

7Turn both handles to their fully-closed positions.

The handles should hook into the sides of the chassis slot. Closing the handles draws the FortiGate-5001FA2 board into place in the chassis slot and into contact with the chassis backplane. The FortiGate-5001FA2 front panel should be in contact with the chassis front panel. When the handles are fully-closed they lock into place.

Alignment Pin

Close

Alignment Pin
Handle	Fully Closed
	and Locked

If the chassis is powered on, as the board slides into place the IPM LED starts flashing blue.

8Fully tighten the left and right retention screws to lock the FortiGate-5001FA2 board into position in the chassis slot.

.

Retention

Screw

Tighten

If the chassis is powered on the PWR LED turns green and the STA LED turns red. The ACC LED also starts flashing red. After a few minutes, if the board is operating correctly the front panel LEDs are lit as described in Table 4.

Table 4: FortiGate-5001FA2 normal operating LEDs

LED	State
PWR	Green
ACC	Off (Or flashing red when the system accesses the flash disk.)
STA	Green
IPM	Off

	FortiGate-5001FA2 Security System Guide
16	01-30000-0379-20080606