Fortinet FortiGate-5001FA2 manual C u r i t y S y s t e m G u i d e

Page 1

S e c u r i t y S y s t e m G u i d e

FortiGate-5001FA2

USB

1

2

3

4

5

6

7

8

 

CONSOLE

 

 

 

 

 

 

 

STA

IPM

PWR ACC

 

 

 

 

 

 

 

Adetailed guide to the FortiGate-5001FA2 Security System. This FortiGate-5001FA2 Security System Guide describes FortiGate-5001FA2 hardware features, how to install the FortiGate-5001FA2 board in a FortiGate-5000 series chassis, how to configure the FortiGate-5001FA2 security system for your network, and contains troubleshooting information to help you diagnose and fix problems.

The most recent versions of this and all FortiGate-5000 series documents are available from the FortiGate-5000page of the Fortinet Technical Documentation web site (http://docs.forticare.com).

Visit http://support.fortinet.com to register your FortiGate-5001FA2 system. By registering you can receive product

updates, technical support, and FortiGuard services.

www.fortinet.com

FortiGate-5001FA2 Security System Guide

01-30000-0379-20080606

Image 1
Contents C u r i t y S y s t e m G u i d e Page Contents For more information FortiGate-5001FA2 security system LEDs Front panel LEDs and connectorsAccelerated packet forwarding and policy enforcement ConnectorsFA2 interfaces and active-active HA performance Base backplane gigabit communicationRAM DIMMs To install FortiGate-5001FA2 RAM DIMMsLocation of FortiGate-5001FA2 RAM Dimm slots Installing SFP transceiversTo install SFP transceivers Changing FortiGate-5001FA2 jumper settingsFortiGate-5001FA2 jumper settings Inserting a FortiGate-5001FA2 board into a chassis To change or verify the JP3 jumper settingBefore inserting the FortiGate-5001FA2 board in a chassis Insertion procedureClosed OpenHandle Unlock FortiGate-5001FA2 normal operating LEDs Removing a FortiGate-5001FA2 board from a chassis All chassis left handle not contacting power switch TroubleshootingFortiGate-5001FA2 does not startup Location of FortiGate-5001FA2 power switch FortiGate-5001FA2 cannot display chassis information All chassis Firmware problemRegistering your Fortinet product Planning the configurationTransparent mode NAT/Route modeCommand Line Interface CLI Choosing the configuration toolWeb-based manager Configuring NAT/Route mode Factory default settingsTo configure interfaces Go to System Network Interface Using the web-based manager to configure NAT/Route modeTo configure the Default Gateway Config system interface edit port2 Using the CLI to configure NAT/Route modeUsing the web-based manager to configure Transparent mode Configuring Transparent modeTo switch from NAT/Route mode to transparent mode To upgrade the firmware using the web-based manager Using the CLI to configure Transparent modeUpgrading FortiGate-5001FA2 firmware Go to System StatusTo upgrade the firmware using the CLI Under System Information Firmware Version, select UpdateFortiGate-5001FA2 base backplane data communication To power off a FortiGate-5001FA2 board Powering off the FortiGate-5001FA2 boardPowering off the FortiGate-5001FA2 board Fortinet documentation Customer service and technical supportRegister your Fortinet product Regulatory compliance Trademarks