Eizo T960 user manual Beep, Performance

Priority setting	Performance
D-Sub	If signals from both inputs are present, the monitor
	gives preference to D-Sub for the cases shown below:
	• When the power of the monitor is turned ON (see
	note 1).
	• When the signal input to D-Sub is changed even if
	active input was BNC.
BNC	If signals from both inputs are present, the monitor
	gives preference to BNC for the cases shown below:
	• When the power of the monitor is turned ON (see
	note 1).
	• When the signal input to BNC is changed even if
	active input was D-Sub.
Manual	The monitor will not detect signals automatically in
	this mode. Select the active input by pressing the
	input signal selection button on the monitor’s front
	panel (see note 2).

1The Input Priority function does not automatically reactivate when the monitor has been in the power saving mode.

2The Input selection button on the front panel can be used to select either D-Sub or BNC as the active input at any time.

Beep

Use this feature to set the beeper ON or OFF. If the beeper is ON, the monitor will generate beep signals as shown below. If the beeper is OFF, the monitor will not beep.

Short beep	•	ScreenManager item selected.
	• ScreenManager parameter adjusted to minimum
		or maximum limit.
	• BNC/D-Sub selection button pressed.
Long beep	•	AUTO-SIZING button pressed.
	• ScreenManager data-save executed.
Four short beeps	•	Monitor not connected correctly.
	•	PC turned off.
	• Monitor received unsupported signal frequency.
Two short beeps	•	Monitor is in the advance notice mode of the Off
every		Timer. The monitor will be in the Off Timer
fifteen seconds.		Mode within 15 minutes.

36 2 ADJUSTMENTS & SETTINGS USING THE SCREENMANAGER