Extreme Networks AG200 manual Safety Information, Considerations Before Installing, Power Safety

A Safety Information

WARNING!

Read the following safety information thoroughly before installing Extreme Networks products. Failure to follow this safety information can lead to personal injury or damage to the equipment.

Only trained service personnel should perform service to Extreme Networks equipment and their components. Trained service personnel have read all related installation manuals, have the technical training and experience necessary to be aware of the hazards to which they are exposed in performing a task, and are aware of measures to minimize the danger to themselves or other persons.

Considerations Before Installing

Consider the following items before installing equipment.

●The system is designed to operate in a typical environmentally controlled Telco environment. Choose an indoor area that has the following characteristics:

■Temperature- and humidity-controlled, such that the maximum ambient room temperature shall not exceed 95ºF (35ºC)

■Clean and free from airborne materials that can conduct electricity (other than normal room dust)

■Well ventilated and away from sources of heat including direct sunlight

■Away from sources of vibration or physical shock

■Isolated from strong electromagnetic fields produced by electrical devices

■Secured, enclosed, and restricted-access, ensuring that only trained and qualified service personnel have access to the equipment

●Establish at least 3 inches clearance on all sides for effective ventilation. Do not obstruct the air intake vent on the front, side, or rear ventilation grills. Locate the system away from heat sources.

Power Safety

When you connect the system to power:

●Plug power supplies only into properly grounded electrical outlets to help prevent electrical shock and comply with international safety standards.

●Make sure the voltage and frequency of your power outlet match the system electrical ratings for the equipment. The building and/or power source must provide overload protection.

●Use only power cords that are certified for use within the country of use. Do not attempt to modify AC power cords.

●Use a surge suppressor, line conditioner, or uninterruptible power supply to protect the system from momentary increases or decreases in electrical power.

Sentriant AG200 Hardware Installation Guide 29