Enterasys Networks VSER-RPU-SYS manual Chapter About the Redundant Power Supply, Overview

Page 13

Chapter 1:

About the Redundant Power Supply

Overview

Note: The VSER-RPU-SYS is compatible with V2H124-24 and V2H124-24T only.

This VSER-RPU-SYS External Redundant Power Supply (RPS) can supply 600 Watts of backup power to four switching devices in the event of an AC loss or failure of an internal power supply.

The system operates in a parallel capacity with a switch’s internal power supply. If a switch's internal power supply fails, the RPS will support the full load of the switch without affecting network operation.

Features and Benefits

Supports four switching devices with 12V DC output

Easy management LEDs located on the front panel

AC line cord can draw power from a different supply circuit

DC line cord provides backup power to the attached device

The power supply will operate under a no-load condition.

Front and Rear Panels

Four power indicators (LEDs) and one fan indicator are located on the RPS’s front panel. The AC supply and DC backup receptacles are located on the RPS’s rear panel.

Figure 1-1. Front and Rear Panels

 

 

VSER-RPU-SYS

1

2

 

3

4

Fan

Rear Panel

1-1

Image 13
Contents VSER-RPU-SYS Page Page Regulatory Compliance Information Bsmi EMC Statement Taiwan Power Cord Set France et Pérou uniquement Declaration of Conformity Contents Tables Figures Figures Features and Benefits Chapter About the Redundant Power SupplyOverview Front and Rear PanelsLED LEDsInstallation Chapter Installing the Redundant Power SupplyEquipment Checklist Selecting a SiteGettingHelp Package ContentsMounting MountingAttaching the Brackets Desktop or Shelf Mounting Connecting Switches to the RPSConnecting Several Switches to an RPS Diagnosing RPS Indicators Appendix a TroubleshootingPower and Cooling Problems Troubleshooting Physical Characteristics Appendix B SpecificationsCompliances SpecificationsIndex Index Index-2 Page E032004-R01 150200042500A