Encore electronic ENNUS1 user manual

Page 11

C.When the installation program asks you to plug-in the USB device, run the “Control Center”.

D.In the Control Center, click the ENNUS1 server that has the desired USB device attached.

E.Click the desired USB device as in the following figure.

F.Click the “Connect” button. Then the message “Manually Connect by your_computer_name” will appear, as in the following figure.

G.Now, the installation program will detect the USB device and continue to install the driver.

H.After the installation is complete, click the USB device in the Control Center and then click the “Disconnect” button to disconnect the USB device.

Now the driver of your USB device is installed.

10

Image 11

Contents

ENNUS1 Table of Contents Introduction Physical Description Package ContentsProduct Overview Product CDAssigning an IP Address to the ENNUS1 Server Basic InstallationConnecting the Hardware Server Names and Server Name Rules Setting the IP AddressPage Page Connect & Disconnect Using the ENNUS1 ServerSubnet Issue IntroductionInstallation of USB Device Driver Page Using the ENNUS1 Server Auto-Connect Printer Page Network Scanner Page USB Storage Request to Connect Limitations Control Center Installing Control CenterQuitting the Control Center Using the Control CenterDisplaying ENNUS1 Server Status Using the ENNUS1 Server’s Web PagesENNUS1 Server’s Web Pages „ General Configuration Setting up ENNUS1 Server ConfigurationPage Page Firewall TroubleshootingLED Indicators Indicators Behavior DescriptionClick Maintenance Click Factory Default Restore Factory DefaultsUsing Init Button TCP/IP Default Parameters ListClick Upload Image Upgrade FirmwareMethod a Using the ENNUS1 Server’s Web Pages Method B Using the Init Button and the Tftp ClientInit Button