Encore electronic ENNUS1 user manual Restore Factory Defaults, Using Init Button

Page 27

Chapter8 Restore Factory Defaults

You may restore the ENNUS1 Server’s default parameters by one of the following methods.

8.1Using the ENNUS1 Server’s Web Pages

1.Go to the ENNUS1 Server’s web page and click CONFIG

2.Enter administrator (default: admin) and password (default: admin).

3.Click Maintenance.

4.Click Factory Default.

5.Click Yes to confirm

8.2Using Init Button

Plug in the power adaptor while pressing the Init button until the USB LED blinks. After that, unplug the power adaptor and then plug in the power adapter again to restart the ENNUS1 server. The ENNUS1 server will now operate using the factory default values.

26

Page 26 Page 28
Image 27
Page 26 Page 28
Contents
ENNUS1 Table of Contents Introduction Physical Description Package ContentsProduct Overview Product CDBasic Installation Connecting the HardwareAssigning an IP Address to the ENNUS1 Server Server Names and Server Name Rules Setting the IP AddressPage Page Connect & Disconnect Using the ENNUS1 ServerSubnet Issue IntroductionInstallation of USB Device Driver Page Using the ENNUS1 Server Auto-Connect Printer Page Network Scanner Page USB Storage Request to Connect Limitations Control Center Installing Control CenterQuitting the Control Center Using the Control CenterUsing the ENNUS1 Server’s Web Pages ENNUS1 Server’s Web PagesDisplaying ENNUS1 Server Status „ General Configuration Setting up ENNUS1 Server ConfigurationPage Page Firewall TroubleshootingLED Indicators Indicators Behavior DescriptionRestore Factory Defaults Using Init ButtonClick Maintenance Click Factory Default TCP/IP Default Parameters ListClick Upload Image Upgrade FirmwareMethod a Using the ENNUS1 Server’s Web Pages Method B Using the Init Button and the Tftp ClientInit Button