Enterasys Networks RBT-8200 ICES-003 Canada, Europe CE Declaration of Conformity, Vcci Japan

Page 35

Electromagnetic Compatibility Notices

ICES-003 (Canada)

Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils numériques de Classe Aprescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, NMB‐003 édictée par le Ministre Canadian des Communications.

English translation of the notice above:

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the interference‐causing equipment standard entitled “Digital Apparatus,” ICES‐003 of the Canadian Department of Communications.

Europe (CE Declaration of Conformity)

This product has been tested in accordance too, and complies with the Low Voltage Directive (73/23/EEC) and EMC Directive (89/336/EEC). The product has been marked with the CE Mark to illustrate its compliance.

VCCI (Japan)

English translation of the notice above:

This is a Class A product based on the standard of the Voluntary Control Council for Interference (VCCI) from Information Technology Equipment. If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

Taiwan Declaration of Conformity

This product has been tested and complies with CNS13438. The product has been marked with the BSMI DOC mark to illustrate compliance.

Korean RRL Compliance

This product has been tested and complies with MIC Notices No. 1997‐41 and 1997‐42. The product has been marked with the MIC logo to illustrate compliance.

Australia/New Zealand

This product has been tested and complies with AS/NZS 3548. The product has been marked with the C‐Tick mark to illustrate compliance.

RBT-8200 Wireless Switch Installation Guide A-5

Image 35
Contents RoamAbout Page Page Regulatory Compliance Information Iii Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Appendix B Wireless Switch Safety Warnings Conventions Used in This Guide About This GuideIntended Audience Associated DocumentsGetting Help Kit Contents RBT-8200 Wireless Switch SetupControl Button Functions Front Panel Controls and IndicatorsLED Watt Power Supply Chassis Back I/O Ports and FeaturesPower Supply Environmental Requirements Physical SpecificationsColor State Description Front Panel System Status LED IndicatorsSystem Status LED Power/Sleep LEDNon-Critical Condition Using the CLI quickstart Command ConfigurationPre-Configuration Tasks Wireless Switch Configuration TasksQuickstart Command Procedure Optionally, enable Telnet Preconfigure the Wireless Switch in Rasm Configuring RoamAbout Wireless Switches Using RasmPreparing the Switch Example 2 Deployment Site Has No Dhcp and No DNS Configure DNS server information Preparing the Network for Distributed Access Points Product EMC Compliance Wireless Switch Regulatory Certification InformationProduct Safety Compliance Product Regulatory ComplianceRegulatory Country Marking Compliance Product Regulatory Compliance MarkingsGost R Marketing Russia FCC Verification Statement USA Electromagnetic Compatibility NoticesTaiwan Declaration of Conformity ICES-003 CanadaEurope CE Declaration of Conformity Vcci JapanRelated Specified Components Wireless Switch Safety Warnings Wireless Switch Safety Warnings RBT-8200 Wireless Switch Installation Guide B-3 Avertissement Français Avertissement Français suite Warnung Deutsch Warnung Deutsch Fortsetzung Avvertenza Italiano Avvertenza Italiano continua Advertencias Español Advertencias Español continúa Advertencias Español Wireless Switch Safety Warnings Index Index-2