Enterasys Networks RBT-8200 manual Power/Sleep LED, System Status LED

Front Panel System Status LED Indicators

Power/Sleep LED

The BIOS controls the front panel Power LED as described in the following table.

Table 1-6 SSI Power LED Operation

State	Power	LED	Description
	Mode
Power Off	Non-ACPI	OFF	System power is off, and the BIOS has not initialized the
			chipset
Power On	Non-ACPI	ON	System power is on, but the BIOS has not yet initialized the
			chipset
S5	ACPI	OFF	Mechanical Off, and the OS has not saved any context to
			the hard disk
S4	ACPI	OFF	Mechanical Off. The OS has saved context to the hard disk
S3-S1	ACPI	Slow Blink 1	DC Power is still on. The OS has saved context and gone
			into some level of low-power state
S0	ACPI	Steady On	System and the OS are up and running

Note: Link rate is ~1 Hz at 50% duty cycle.

System Status LED

Critical Condition

Any critical or non‐recoverable threshold crossing associated with the following events:

•Temperature, voltage, or fan critical threshold crossing.

•Power subsystem failure. The BMC asserts this failure whenever it detects a power control fault (for example, the BMC detects that the system power is remaining on even though the BMC has instructed the signal to turn off power to the system). A hot‐swap backplane would use the Set Fault Indication command to indicate when one or more of the drive fault status LEDs are asserted on the hot‐swap backplane.

•The system is unable to power up due to incorrectly installed processor(s), or processor incompatibility.

•Satellite controller sends a critical or non‐recoverable state, using the Set Fault Indication command to the BMC.

•“Critical Event Logging” errors, including: System Memory Uncorrectable ECC error and Fatal/Uncorrectable Bus errors, such as PCI SERR and PERR.

RBT-8200 Wireless Switch Installation Guide 1-7