Chassis Back I/O Ports and Features
Chassis Back I/O Ports and Features
Figure 1‐2 shows the back I/O Ports and features for the RBT‐8200 Wireless Switch.
Figure 1-2 Back I/O Ports and Features
A. Not supported B. Not supported C. RJ45 Serial B
D. NIC 1, NIC 2 connector E. Not supported
F. Not supported
G.Not supported H.Not supported I. Not supported J. Not supported K. Not supported
L.AC Power Connector M. Not supported
Power Supply
250 Watt Power Supply
The 250 watt power supply is rated for 250 watts of power at the following voltages and is rated as follows:
•
•
Warning: Do not attempt to modify or use the supplied AC power cord if it is not the exact type required.
The power supply cord is the main disconnect to AC power. The socket outlet must be installed near the equipment and readily accessible.
If the power cord supplied with the system is not compatible with the AC wall outlet in your region, get one that meets the following criteria:
•The cord must be rated for the available AC voltage and have a current rating that is at least 125 percent of the current rating of the server.
•The plug on the power cord that plugs into the wall outlet must be a
•The connector that plugs into the AC receptacle on the power supply must be an IEC 320, sheet
•In Europe, the cord must be less than 4.5 meters (14.76 feet) long, and it must be flexible <HAR> (harmonized) or VDE certified cordage to comply with the chassis’ safety certifications.