Enterasys Networks 9E312-12 manual FCC Notice, Vcci Notice

Page 3

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

VCCI Notice

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

ii

Image 3
Contents MMAC-Plus9E312-12 Ethernet Switch Module User’s Guide Page Vcci Notice FCC NoticeDOC Notice Contents Contents Introduction Processor FeaturesINB 9E312-12 Module Getting Help Related ManualsInstalling the 9E312-12 Module Installing the 9E312-12 Module Pin PinoutsReset Switch User Accessible Components E312-12 Module DIP Switch location Setting the 9E312-12 Module DIP SwitchNVRAM-2 Front Panel Ports OperationI960 Host Fast Packet SwitchSystem Management Buses System Diagnostic ControllerINB Interface DC/DC ConverterSystem Status Lanview LEDsLED Color State Description Function of the INB Transmit LEDs are listed in Table Function of the Port Transmit LEDs are listed in Table Technical Specifications SpecificationsSafety ServicePhysical Environment