Enterasys Networks 9E312-12 manual NVRAM-2

Setting the 9E312-12 Module DIP Switch

!

CAUTION

See the Cautions at the end of this table.

	Table 2-2. Function of DIP Switch
Switch	Function	Description
		This module stores user entered passwords in
		NVRAM (Nonvolatile random access memory). To
		clear these passwords, toggle this switch and then
8	Clear	reset the module’s processor. Once the module resets,
	Password-1	factory default passwords are placed in NVRAM. You
		can use these default passwords or, if desired, enter
		new passwords. To enter new passwords, refer to the
		Module Local Management User’s Guide.
		This module stores user entered parameters such as IP
		addresses, subnet masks, default gateway, default
		interface, SNMP traps, bridge configurations and
		module specific configurations in NVRAM. To clear
7	Clear	these parameters toggle this switch and then reset the
	NVRAM-2	module’s processor. Once the module resets, factory
		default parameters are placed in NVRAM. You can
		use the default parameters or, if desired, enter new
		parameters. To enter new parameters, refer to the
		Module Local Management User’s Guide.
		This module uses BOOTP (Boot Strap Protocol) to
	Force	download new versions of the image file into Flash
		Memory. This procedure forces image files to be
6	BOOTP
		downloaded from the PC or Workstation, configured
	Download
		to act as the BOOTP server, connected to the EPIM
		port in the Environmental Module.
5	Reserved	For Factory Use Only
4	Reserved	For Factory Use Only
3	Reserved	For Factory Use Only
2	Reserved	For Factory Use Only
1	Reserved	For Factory Use Only

1.Caution: Do not toggle Switch 8 unless you intend to reset the user configured passwords to the factory default settings.

2.Caution: Do not toggle Switch 7 unless you intend to reset the user parameters to the factory default settings.

2-7