Dialogic® DSI SPCI Network Interface Boards Programmer's Manual Issue 5
up_enable - User Part Enable
A 16 bit mask used to enable or disable reception of messages on a per user part basis. If bit N is set to 1, then messages for user part N are received by the signaling point.
For example, to enable the TUP User Part (Service indicator = 4) set the up_enable field to 0x0010, For ISUP (Service Indicator = 5), set the up_enable field to 0x0020. To use both TUP and ISUP, set up_enable to 0x0030.
linkn_flags - Per link flags
Bit 0 is set to 1 to force the use of the emergency proving period during link alignment. This bit is usually set to zero and uses the appropriate proving period according to Q.703.
Bit 1 is set to 1 to cause a signaling link test (in accordance with
Bit 2 is set to 1 to cause a signaling link test (in accordance with
Bit 8 is used to select the MTP2 error correction mode. It is set to 1 to select PCR (Preventive Cyclic Retransmission) operation, or zero for the Basic Method of Error Correction.
Bits 10 and 11 are used to select the data rate for the link as detailed below.
Bit 11 | Bit 10 | Data Rate |
0 | 0 | 64kbps |
|
|
|
1 | 1 | 56kbps |
|
|
|
0 | 1 | 48kbps |
|
|
|
Note: When using a serial port, 56 kbps and 48 kbps operation is only supported when the clock is applied externally.
Bit 13 is only used when the link has been configured to run over a serial port (i.e., bit 14 is set). If set to 1, an external clock is used (Receive clock). If set to zero, an internal clock (Transmit clock) is used. If the link has not been configured to run over a serial port, this bit must be set to zero.
Bit 14 is set to 1 to use a serial port, rather than a PCM timeslot for this link. In this mode the stream and timeslot parameters for this link are ignored (and must be set to zero). If this bit is set to zero, the link uses the specified stream and timeslot. The serial port used by the signaling processors for each link is fixed, according to the following table:
linkn | Serial Port | |
0 | B | |
|
|
|
1 | A | |
|
|
|
2 | Cannot be used for a serial port. | |
|
|
|
3 | Cannot be used for a serial port. | |
|
|
|
|
|
|
47