Dialogic® DSI SPCI Network Interface Boards Programmer's Manual Issue 5
If using Switch address mode , board_id = 0 would be the board with ADDR switch set to 6, board_id = 1 would be the board with ADDR switch set to 4 and so on.
It is not necessary for all boards listed in this parameter to actually exist in a system. Any board listed, but missing, would result in a gap in the logical board_id sequence.
Show version information.
Enable diagnostic tracing.
8.2s7_mgt
8.2.1Description
The s7_mgt utility performs
8.2.2Syntax
s7_mgt
8.2.3Command Line Options
The s7_mgt utility supports the following command line options:
Show version information.
-k<config file>
Specifies the SS7 configuration file. The default is config.txt.
-m<module id>
Specifies the unique module ID that is assigned to s7_mgt for the Inter Process Communication (IPC) environment. The module ID may be entered in decimal or hexadecimal (prefixed by 0x) format. If the module ID is not specified, the utility uses a module ID of 0xcf. The module ID assigned must have a corresponding LOCAL entry in the system.txt file and must not be in use by any other process on the host.
109