Configure Group a, Office Lighting | Eaton Electrical 1000 specs

Hit SEL to select Group A. The following menu is displayed:

CONFIGURE GROUP A

Group A GRPA ON

OFFICE LIGHTING

Associate Loads______

Associate Inputs

Modify Schedules

Modify Description

A. Associate Loads With the Group

Hit SEL to select Associate Loads. The following screen is displayed:

ASSOCIATE LOADS

With Group A

Select loads for this group individually

Add all loads which are currently ON

Clear all loads from this group

There are two ways to choose which loads are associated with the group. Hitting SEL on the Select loads for this group individually will present the following screen:

PICK GROUP A LOADS

USE SEL to TGL LOAD

PNL1 Load 16 BK16 YES

LIGHTING – R101

PNL1 Load 17 BK17 YES

LIGHTING – R102_____

PNL1 Load 18 BK18 NO

Each load (breaker) will be listed by panel, followed by its current membership in this group (YES/NO) and by its description, if one has been entered (LIGHTING – R102 in the above example). Use UP/ DOWN to scroll up and down through the breaker list and SEL to change to membership setting to YES or NO. After all loads have been selected for this group, hit BACK twice to return to the CONFIGURE GROUP A screen.

The second option for associating loads is the Add all loads method. To use this option, turn ON the primary handle and the con- trol handle for all loads that will be part of this group. Turn OFF the primary handle for all loads that will not be part of this group. Then UP/DOWN to move to the Add all loads… option. Hit SEL to choose all currently ON breakers. This may take several minutes while all breakers are scanned. After all loads have been selected for this group, hit BACK twice to return to the CONFIGURE GROUP A screen.

B. Associate Inputs With the Group

If a switch input will be associated with this group, use UP/DOWN to highlight the Associate Inputs. Hit SEL to move to the input select screen:

INPUT for GROUP A is currently #7 Change input to:

Input 7 DI01 (OFF)

Maintained + 5 min_

Use up/down to change

Input, SEL to accept

Use UP/DOWN to cycle through the available inputs. When the correct input is displayed, hit SEL to associate it with the group. The input type screen will then be displayed:

Select the type of switch on Input 7

Maintained__________

Maintained(inverted)

Momentary ON / OFF

Maintained Change

Motion Sensor

Photocell

The list of input types extends beyond one page. Use UP/DOWN to scroll through the choices and highlight the correct switch type. Hit SEL to choose it.

Note: Three-way and 3-wire momentary switches require two physi- cal inputs paired together. Inputs 1 and 2, 3 and 4, 5 and 6, etc., are paired together by the system. Selecting either one of them as the input will cause the other to be automatically selected for these types of switches.

The delay time screen will be shown next:

Select the delay time time for Input 7

-15 minutes

None_________________

15minutes

30minutes

45minutes (enter exact time)

To have the load stay on for a certain number of minutes after the input has turned off, use UP/DOWN and SEL to pick a number of min- utes. Otherwise, hit SEL on the None value. A value other than 15, 30 or 45 can be entered by choosing the enter exact time selection.

Hit BACK three times to return to the CONFIGURE GROUP A screen.