LCD Programming Procedure
1. Press any key to begin. The Eaton logo will be displayed:
After a few seconds, the firmware version will be displayed:
FIRMWARE VERSION A1
After a few more seconds, the initial status screen will be displayed:
Aug 25, 2006 11:28A
Group Status:
ON: ABC | N |
OFF: DEFGHIJKLM OP
Press SEL for menu
Press SEL to get to the MAIN MENU.
2. Login
If user passwords have been created on your system by your distrib- utor/installer, you will see the following screen. Use UP/DOWN to enter the letters of your password and the SEL key to advance to the next letter. Advance the cursor past the end of the blanks to submit the password.
Aug 25, 2006 11:28A
User ID:
________
If this LCD tool has just been powered up, it will have to download a database from the PRC1000 controller. You may see the following screen with the progress indicator:
Aug 25, 2006 11:28A
Refreshing Database
Please wait... 57%
Press BACK to quit
The database may take up to 10 minutes to download during initial startup. Afterwards, the MAIN MENU will be displayed:
MAIN MENU |
| |
Command | Groups ON/OFF |
|
Panel Status Screen |
| |
Configure Groups |
| |
Configure Date/Time | _ | |
Group | Status: |
|
ON: ABC | N |
|
OFF: | DEFGHIJKLM OP |
|
3. Set Date/Time/DST/Location
From the MAIN MENU, select Configure Date/Time. The follow- ing menu will be displayed:
CONFIGURE DATE/TIME
Change Date__08/23/06
Change Time 11:37 AM
Change DST MANUAL
St: mm/dd End: mm/dd
Change Astro Loc.
Use UP/DOWN to select Change Date. Use SEL to move through the date digits. Use UP/DOWN to set the month, day and year, respec- tively. After setting the year, hit SEL one more time. The new values will be displayed on the PRC1000.
Use UP/DOWN to highlight Change Time. Use SEL to move through the time digits. Use UP/DOWN to set the hour, minute and AM/PM, respectively. After setting the AM/PM, hit SEL one more time.
The new values will be displayed on the PRC1000.
Use UP/DOWN to highlight Change DST. Use SEL to start editing the DST setting. Use UP/DOWN to choose NONE, AUTO or MANUAL. If MANUAL is chosen, settings for start and end date will appear. Hit SEL to jump to the start date. Use UP/DOWN to set the month and day values. Use SEL to move through the digits. After setting the DST setting (or dates for MANUAL), hit SEL one more time. The new values will be displayed on the PRC1000.
Use UP/DOWN to highlight Change
ASTRO LAT: 33.00
LON: 84.00
TIMEZONE: 5
RISE 06:30 SET 07:00
Use UP/DOWN to set the latitude value in degrees. The latitude range is
Note: Sunrise/sunset calculations lose accuracy outside the
4. Configure Breaker Group A
From the MAIN MENU, select Configure Groups. The following screen will be displayed:
SELECT GROUP
TO CONFIGURE:
Group A GRPA | OFF |
GROUP A LIGHTS
15 loads in group.
Use up/down/sel to change selection
The group is shown, followed by its current status (OFF in this example). The next line is the group description, if it exists (GROUP A LIGHTS in this example), followed by the number of loads (breakers) that has been associated with this group (15 in this example).
2 | EATON CORPORATION |