Edgeport/412, Edgeport/416

The Edgeport/412 and Edgeport/416 utilize a standards-based USB bus for connectivity, unlike many serial card products which require additional external proprietary hardware to support the same number of devices. This Edgeport also supplies four USB ports, providing users with a built-in migration path as peripherals become USB- ready. The converters can be rack mounted and easily daisy-chained together. These Edgeport converters are available in two models: one with DB25 connectors and one with DB9 connectors. The two models are functionally equal, but differ in the type and placement of the connectors.

Cabling Edgeport

Type A

Type B

Connect one end of the power supply into the back of your Edgeport and the other end into an AC outlet.*

To connect your Edgeport to a PC or Hub, plug the Type A end of the USB cable into the USB port located in the back of your PC or into an available USB port on a standard hub or into a Digi Hubport. Plug the Type B end of the USB cable into the back of the Edgeport/412 or 416.

To connect a USB device to your Edgeport, plug the Type A end of the USB cable into one of the Edgeport’s USB Type A slots and the Type B end of the USB cable into the device (e.g. a Rapidport, Hubport, Edgeport/421, etc.).

* Power to the Edgeport-DB25 and Edgeport-DB9 may be supplied	by a UL Listed Direct Plug-In Power Unit or Information	+	-
Technology Equipment Rated Power Unit rated 5 V dc, at least 2.9	A if used in the U.S. and Canada or a power supply with

similar rating and approved by your local safety code if it is used elsewhere. For polarity, see diagram to the right.

If the drivers are not already installed, go to "Edgeport Driver Installation” on page 8.

Edgeport Installation Guide (90000403 Rev. D) – Page 5