Digi Edgeport/4, Edgeport/8rr, 412, 21 Regulatory & Other Information, For U.S. Government use

Page 21

Regulatory & Other Information

© 2006 Digi, Digi International, the Digi logo, Inside Out Networks, Edgeport, and Hubport are either trademarks or registered trademarks of Digi International, Inc. in the United States and/or other countries. All other trademarks are the property of their respective holders.

Information in this documentation is subject to change without notice and does not represent a commitment on the part of Digi International.

Digi International provides this document “as is,” without warranty of any kind, either expressed or implied, including, but not limited to, the particular purpose. Digi International may make improvements and/or changes to this documentation or to the product(s) and/or program(s) described in this documentation at any time.

Digi International assumes no responsibility of

any errors, technical inaccuracies, or typographical errors that may appear in this documentation, nor liability for any damages arising out of its use. Changes are made periodically to the information herein; these changes may be incorporated in new editions of the publication.

For U.S. Government use:

Any provision of this document and associated computer programs to the U.S. Government is with “Restricted Rights.” Use, duplication, or disclosure by the government is subject to the restrictions set forth in, subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause of DFARS 52.277-7013.

For non-U.S. Government use:

These programs are supplied under a license. They may be used, disclosed, and/or copied only as supplied under such license agreement. Any copy must contain the above copyright notice and restricted rights notice. Use, copying, and/or disclosure of the programs is strictly prohibited unless otherwise provided for in the license agreement.

Federal Communications

Commission (FCC) Regulatory

Information (USA only)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet that is on a circuit different from the receiver.

Consult the dealer or an experienced radio/TV technician for help.

Warning: The connection of a non-shielded interface cable to this equipment will invalidate the FCC Certification for this device.

FCC Regulation - Part 15

Declaration of Conformity (DoC)

This device complies with the requirements of the Code of Federal Regulations listed below:

FCC Title 47 CFR, Part 15 Class B for a digital device.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

Edgeport Installation Guide (90000403 Rev. D) – Page 19

Image 21
Contents Edgeport Table of Contents Edgeport Products Cabling Edgeport Edgeport/8r RJ-45 Pin AssignmentsEdgeport/8rr RJ-12 Pin Assignments Edgeport/21 Edgeport/42, Edgeport/421 Installing the Hub DriversFor Windows 95 Users For Windows 98, CE, SE, Me, 2000 and XP UsersFor Windows 95, 98, CE, SE, Me, 2000, XP and NT Users Using the Printer PortEdgeport/412, Edgeport/416 Edgeport/2c Installing the Printer Port Edgeport/21c, Edgeport/22cFor Windows 98, CE, SE, Me, 2000, and XP Users For Windows XP, 2000, and 2003 Server Edgeport Driver InstallationFor Windows 98, and Me For Windows NTFor Windows For All Edgeports except the Edgeport/1 System Status LightMounting Diagrams Edgeport Utility Program For All Windows Operating SystemsGeneral Tab Edgeport Installation Guide 90000403 Rev. D Edgeport Installation Guide 90000403 Rev. D Edgeport Installation Guide 90000403 Rev. D Version Tab Advanced Tab Understanding Hubs Example of a Typical Hub ConfigurationFor U.S. Government use Regulatory & Other InformationFor non-U.S. Government use FCC Regulation Part Declaration of Conformity DoCEuropean Community CE Mark Declaration of Conformity DOC Department of Communication DOC Notice Canada onlyDigi International UL/CSA Safety InformationEN 55022 Class B 1994 w/A1 EN55024