How to Attach Options to the Plasma Monitor
You can attach your optional mounts or stand to the plasma monitor in one of the following two ways:
*While it is upright. (See Drawing A)
*As it is laid down with the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face.
*Do not touch or hold the screen face when carrying the unit.
•This device cannot be installed on its own. Be sure to use a stand or original mounting unit. (Wall mount unit, Stand, etc.)
* See the inside of the cover page.
•For correct installation and mounting it is strongly recommended to use a trained, authorized dealer.
Failure to follow correct mounting procedures could result in damage to the equipment or injury to the installer.
Product warranty does not cover damage caused by improper installation.
* Use only the mounting kit or stand provided by manufacturer and listed under Options.
Drawing A
Drawing B
Some models are equipped with handles.
When installing or carrying, use the handles attached to the upper back of the display.
Ventilation Requirements for enclosure mounting
To allow heat to disperse, leave space between surrounding objects as shown on the diagram below when installing.
| Wall |
|
50mm (2") | 50mm (2") | (2") |
|
|
mm | Wall | ||
50 |
| ||
|
| ||
|
|
|
|
|
|
|
|
How to use the safety metal fittings and the screws for safety metal fittings
These are fittings for fastening the unit to a wall to prevent tipping due to external shock when using the stand (optional). Fasten the safety fittings to the holes in the back of the monitor using the safety fitting mount screws. * Safety metal fittings will differ according to the model.
Screw hole
Screw or Hook etc. (Not supplied)
50mm (2") (2")mm 50
Safty metal fittings
Screw for Safty metal fittings
Metal chain (Not supplied)
Wall |
Table Top
1
