Digi MIL-4511H manual Micro Modules used with the MIL 4511H, MIL 4511H Packag e Contents

Page 2

Install Guide

Micro Modules used with the MIL - 4511H:

•MIL-4310M

•MIL-4320M

•MIL-4330M

•MIL-4340M

•MIL-4350M

•MIL-4360M

•MIL-4370M

For instructions on conﬁguring the micro modules, see the MIL-4300M Series Micro Module Installation Guide.

HUB 24Port 10BaseT with Modular Uplink Ports, SNMP Management Module Installed
	STACK
		MBUS
		PWR
IN	OUT	RX	CX
IN	OUT	MSYS

MODEL MIL•4511 LINK RECEIVE

PARTITION

•MIL-4511H SNMP Managed Hub

•Power cord

•One, 6-wire, interconnect data cable

•Warranty Card

•Two Rack mount ears

•Four Rubber feet

If any items is missing, return the entire unit to the place of purchase immediately.

Model: MIL-4511H

Image 2

Contents MIL-4511H MIL 4511H Packag e Contents Micro Modules used with the MIL 4511HDescription of the LEDs Description of Dip SwitchesDescription of Hardware DB 9 Serial Por t Installation ProcedureInstallation of Micro Modules Installation of the Rubber Feet MIL4511 ModelInstallation of the Interconnect Cable Stacking Multiple HubsAssigning an IP Address Por t RedundancyCascading Hubs Arp -s ether alpha 040c80012B Setting the IP Address with TelnetAlpha Arpbypass set alpha 0x00.0x40.0xc8.0x00.0x01.0x2B0040c802abcdalpha Setting the IP Address with RarpSetting the IP Address with Bootp Usr/etc/rarpd-a or /etc/rarpd-aAlphaht=1ha=0040c8010203ip=199.86.12.183 To set the IP Address with Bootp on a HP/UX systemHostname of MIL-4511Hht=1ha=hardware addressip=ip address Alpha is alive Verifying the IP Address is Set ProperlyPing hostname Ping ip-addressFive-Year Limited Warranty Legal