Digi MIL-4511H manual Installation of the Rubber Feet, MIL4511 Model

Install Guide

Installation of Rack Mount Ears

Do the following to install the rack mount ears

1.Starting with one side of the hub, remove the three screws closest to the front of the hub with a Phillips head screwdriver.

2.Place one of the two rack mount ears next to the hub, aligning the three holes that form a triangle with the three holes on the hub (see illustration below):

HUB 24Port 10BaseT with Modular Uplink Ports, SNMP Management Module Installed
	STACK
		MBUS
		PWR
IN	OUT	RX	CX
		MSYS

MODEL MIL•4511 LINK RECEIVE

PARTITION

3.Secure the ears by returning the screws back into the correct holes on the hub.

4.Repeat this procedure to install the other rack mount ear.

Note: The MIL-4511H does not ship with rack screws. Check your rack manufacturer for the proper size rack screw.

Installation of the Rubber Feet

The MIL-4511H ships with four rubber feet that are to be installed on the bottom of the hub. Do the following to install the four rubber feet:

1.Remove the plastic stickers on of the rubber feet.

2.Place a foot on one corner of the bottom of the hub (see illustration below):

3.Press the foot down firmly so it remains in place.

PARTITION
RECEIVE	MIL•4511 MODEL
LINK

CX	MSYS	OUT	IN
	RX
	PWR
	MBUS
		STACK

Installed Module Management SNMP Ports, Uplink Modular with 10BaseT 24Port HUB

4. Repeat this procedure for the other three feet.

Note: Be sure to place the feet on the corners of the hub and do not block air vents.

Model: MIL-4511H 5