Dell W-3000 manual Tabletop Deployment, Initial Setup and Network Connectivity, Removal

Page 16

Tabletop Deployment

To deploy an W-3000 Series Controllers on a flat surface, such as a tabletop:

1.Insert the four rubber mounting feet to the bottom of the unit.

2.Attach side bezels by snapping them into place.

3.Place the unit on a hard flat surface.

Initial Setup and Network Connectivity

Once the physical installation is complete, run the initial setup on the controller to configure the IP address and other basic system information. For complete details and instructions, refer to the ArubaOS Quick Start Guide for the software version installed on your controller.

Removal

To remove the W-3000 Series Controllers from a 19-inch (48.26 cm) rack system:

1.Disconnect the power to the controller by unplugging the power cord from the electrical outlet.

2.Disconnect any other cables or devices attached to the controller.

3.Loosen the four rack mount screws securing the controller to your organizations rack system.

4.Remove the controller from the rack system.

16 Installing the W-3000 Series Controllers

Dell PowerConnect W-3000 Series Controller Installation Guide

Image 16
Contents Installation Guide Copyright Contents Page Related Documents Guide OverviewContacting Dell About This Guide Package Checklist Minimum Software RequirementsModel Overview 1000Base-X SFP Ports10/100/1000Base-T Gigabit Ethernet Ports Serial Console PortAC Power Socket LED Status IndicatorsUse About the PowerConnect W-3000 Series Controllers For a Telecom Rack Installation in a Telecom RackFor a Server Rack Rack Mount Brackets Installation in a Server Rack Air Flow RequirementsTabletop Deployment Initial Setup and Network ConnectivityRemoval Physical Specifications Power Management SpecificationsOperating Specifications Power ConsumptionStorage Specifications Safety and Regulatory ComplianceFCC Class a Device Industry Canada NOM Information Mexico Only Proper Disposal of Dell EquipmentEuropean Union RoHS July 2010