CyberPower Systems UP425 user manual Definitions for Illuminated LED Indicators, Breaker

DEFINITIONS FOR ILLUMINATED LED INDICATORS

							Condition
Power	Using	Wiring	Circuit	Alarm
On	Battery	Fault	Breaker
On	Off	Off	Set	Off	Normal
Off	On	On/Off	Set	Two	Utility Failure- The UPS is providing battery power
				Beeps
					to the Battery-Power Supplied outlets.
Off	On	On/Off	Set	Rapid	Utility	Failure- The		UPS is		providing	battery
				Beeps	power.	The rapid beeps indicate the battery will
					run out of charge within a few minutes.
				Two	Overload-		Occurs	in	the	Full-time	Surge
				beeps
					Protection Outlets. Turn the UPS off and unplug
Off	On	Off	Up	or
					at least one piece of equipment from the UPS.
				rapid
					Wait 5 seconds, reset the circuit breaker and turn
				beeps
					the UPS on.
Off					Overload- Occurs in the Battery-power Supplied
	On/Off	On/Off	Set	Long	Outlets. Turn the UPS off and unplug at least one
				Beep	piece of equipment from the UPS.						Wait 5
					seconds, reset the circuit breaker and turn the
					UPS on.
					Electrical Wiring Fault- This indicates a wiring a
					problem such as a bad ground, missed ground or
On/Off	On/Off	On	Set/Up	None	reversed		wiring within		the AC outlet.		User is
					advised to disconnect all electrical equipment
					from the outlet and have the outlet checked by an
					electrician.

6