Deploying the Dell PowerConnect 8100 with the Cisco Catalyst
console(config)# interface range te1/0/47-48 console(config-if)#channel-group 1 mode active console(config-if)#no shut console(config-if)#exit console(config)#po1 console(config-if-Po1)#switchport mode trunk
console(config-if-Po1)#switchport trunk allowed vlan 100,101 console(config-if-Po1)#no shut console(config-if-Po1)#exit
OR using general Mode changing only the configuration for Po1
console(config)#po1 console(config-if-Po1)#switchport mode general console(config-if-Po1)#switchport general allowed vlan add 100,101
tagged
console(config-if-Po1)#no shut console(config-if-Po1)#exit
Cisco Catalyst CLI
Here are the commands to run on the Cisco Catalyst 6504:
Cat6504E_1#configure terminal Cat6504E_1(config)#vlan 100,101 Cat6504E_1(config-vlan)#exitCat6504E_1(config)#interface range te2/1-2Cat6504E_1(config-if-range)#switchportCat6504E_1(config-if-range)#channel-group 1 mode active Cat6504E_1(config-if-range)#exitCat6504E_1(config)#interface po1 Cat6504E_1(config-if)#switchportCat6504E_1(config-if)#switchport trunk encapsulation dot1q Cat6504E_1(config-if)#switchport trunk allowed vlan 100,101 Cat6504E_1(config-if)#switchport mode trunk Cat6504E_1(config-if)#no shutdown Cat6504E_1(config-if)#exit