Channel Vision IR-4101 warranty Mounting the IR receiver Option 1 Using the holster

			Basic IR-on-coax Setup	Using the IR-4101 with an E-series IR modulator			Mounting the IR receiver: Option 1 - Using the holster
A basic IR system, like the one shown below, is often used when an
audio/video signal is distributed to a remote TV location using the RF							Mount the IR receiver to the TV or on a surface within line of sight
output of the device. The IR-4101 is located near the TV, allowing IR					IR-4101
							of your remote control.
signals to be detected, and the IR-4000 is located near the audio/video
source, providing an IR emitter output.
IR-4101
				DC Block
					IR-4101
			TV set	C H A N N E L V I S I O N
				OUT/in	OUT/in		Remove the backing from the tape and attach the
				5MHz-1GHz All Port DC passing
				Part No. HS-4
				4-WAY SPLITTER/COMBINER
				OUT/in IN/out	OUT/in		IR receiver holster in the desired location.
				HS-4
				DC Passing
				splitter
				DC Block and
	IR-4000			75 ohm terminator
C H A N N E L V I S I O N
To IR coax adaptor	IR-4000	Input
	IR coax engine			IR Emitter
IR emitter		Pwr
							Snap IR receiver head into the holster
							as shown.
			Ch. 3 output		T M
				DVD player
					CHANNEL VISION	E S e r i e s
	IR Emitter		VCR			A B
					E 2 2 0 0 I R

Mounting the IR receiver: Option 2 - Using the hole mount	Mounting the IR receiver: Option 3 - Using the tabletop mount
	Push the IR receiver head
	through the hole in the
	tabletop mount.
Drill a 3/4” hole.
Push the IR receiver head
through the hole.
Insert the IR receiver head
into the IR receiver hole mount.	Insert the IR receiver head		To secure the mount, remove
	into the IR receiver hole mount.		the backing from the foam tape
		Push the IR receiver hole	on the bottom of the unit and
			attach the mount to any flat surface.
		mount and IR receiver head
		back into the hole in the tabletop
		mount.

Push the IR receiver hole mount and IR receiver head back into the hole.