Optimus SCT-56 owner manual Using Relay Play, Playback Sequence

Page 9

Special Features

Using Relay Play

You can load two cassette tapes to play one after the other.

Notes:

The cassettes you load should have the same Dolby NR type.

You can start relay play from either Deck 1 or Deck 2.

You can replace the tape in the idle deck during relay play.

When a tape automatically begins playing during relay play, it always starts from the forward () playback side. Be sure to set the tapes properly before starting relay play.

If the deck encounters an unrecorded portion of tape more than 15 seconds long, it fast forwards the tape until it finds another recorded portion, and resumes playback from that point (i.e., blank skip is automatically set).

1.Load a cassette tape in each tape compartment, then close the compartment doors.

2.Set DOLBY NR for the noise-reduction system you want to use. See “Dolby Noise Reduction” on Page 7.

3.Set REV MODE to RELAY/SKIP.

4.Press or on Deck 1 or 2. Playback starts. See “Playback Sequence.”

5.Adjust the volume, tone, and balance control on your receiver/ amplifier for the desired sound.

6.To stop relay play before it automatically stops, press STOP () on the deck that is playing any time during playback.

Playback Sequence

The cassette deck repeats the following sequence 8 times (up to 32 sides).

Where playback starts in the sequence depends on which play button you press first:

I.Side facing out, Deck 1

II. Side facing in, Deck 1

III. Side facing out, Deck 2

IV.

Side facing in, Deck 2

When you press on Deck 1, playback starts at I.

When you press on Deck 1, playback starts at II.

When you press on Deck 2, playback starts at III.

When you press on Deck 2, playback starts at IV.

9

Image 9
Contents High-Speed Dubbing Stereo Cassette Deck Please read before using this equipmentDolby HX Pro System FeaturesImportant Safety Instructions Contents Connecting the Remote Control Cable Connecting PowerConnections Basic Operation Loading a Cassette TapePlaying a Cassette Tape Setting Dolby NR for Playback Setting Dolby NR for RecordingRecording with the Dolby HX Pro System Fast-Forward/Rewind Special FeaturesPause Blank SkipPlayback Sequence Using Relay PlayDemo Mode Recording from Line-In Sources Recording and DubbingCopying a Cassette Tape Dubbing Recording Blank Spaces Between SelectionsCD-Deck Synchro Recording Restoring Tape Tension and Sound Quality Tape HintsErasing a Cassette Tape Erase-Protection TabsCleaning the Tape-Handling Parts Care and MaintenanceSymptom Cause Remedy TroubleshootingRecord again Specifications Control Index to Features by Control NameRadio Shack Division of Tandy Corporation Fort Worth, Texas