Optimus SCT-56 owner manual Record again

Symptom	Cause		Remedy
There is too much noise.	• Poor-quality tape is being used.	• Use a better-quality tape.
	• There is a faulty connection.	•	Check all connections.
	• Recording level is too low.	•	Turn up REC LEVEL and re-record.
	• The tape heads are dirty.	• Clean the tape heads.
ASMS does not operate properly.	• Blanks between selections are less than 4 sec-	• Use tapes with blanks of 4 seconds or more
	onds long.		between selections.
The system remote control does	• The control cord is not connected.	• Properly connect the control cord.
not work.	• The audio cables are not connected.	• Properly connect the audio cables.
CD-deck synchro recording does	• The CD-deck synchro control cord is not con-	• Properly connect the control cord.
not work.	nected.
	• The cassette tape’s erase protection tabs are	• Replace the cassette with one with unbroken
	broken.		tabs or cover the holes with tape.
The CD-DECK SYNCHRO stops	• The end of the tape was reached during CD-	• Replace the tape with a longer one.
working during CD-Deck Syn-	Deck Synchro recording.
chro recording.
	• After the deck entered the standby mode, more	•	Change the disc and press CD SYNCHRO
	than 1 minute elapsed before the CD player		RECORD again.
	resumed play.

17