Back-to-Back with Frame Relay | Carrier Access 002-0118-0180

Back-to-Back with Frame Relay

The following configuration will set up two Routers back-to-back with Frame Relay.

BoulderDenver

1.1.1.1/241.1.1.1/24

set clock1 internal set 1 default disconnect a:1

disconnect 1

set a:1:all type data connect a:1:all 1:1:1

rename 1 "LocalUnit" "Boulder"

rename 1 "RemoteUnit" "wan1"

set 1:1 ip address 1.1.1.1 255.255.255.0

add 1 "wan1" static ip network

2.2.2.0255.255.255.0 1 set 1:1:1 encapsulation fr set 1 lmi disable

set 1 "wan1" trunk 1

set 1 "wan1" dlci 101 reset 1

Set primary master transmit clock source

Set Router to default settings

Disconnect all connections to the T1 on the Controller (slot a)

Disconnect all connections to the router in slot 1

Set the T1-1 of the Controller, Type to Data

Connect all of T1-1 to the Router that is in slot 1

Rename the Adit 600 from "LocalUnit" (default) to "Boulder" (LAN)

Rename WAN #1 from "RemoteUnit" (default) to "wan1"

Set the Ethernet IP address, in the conventional IP address format. (Router LAN)

Adds a static IP network (route) to the WAN interface

Set the encapsulation on trunk 1 to Frame Relay

Disable LMI (Local Management Interface)

Set the WAN interface named "wan1" to be mapped to trunk 1

Set the DLCI number

Reboot the router, to enable all configurations set

IP Router - Release 1.8