Carrier Access 002-0118-0180 quick start Installation, Basic Setup

Page 4

Quick Start Guide

Installation

Installation

Installation of the router card into the chassis.

λUnit can be on or off

λRouter card will work in any slot

λSlide card into slot until fully seated

λRouter has completed it’s boot cycle when CRD light is solid

The following setups are all executed with CLI

NOTE: Configuration can be done with the following CLI commands or with the Router Menu-Driven Software.

Basic Setup

Command

set {ds0-addr} type data

connect {slot:port:trunk} {slot:port:channel}

set {router-addr} proxy

set {slot:port} up

telnet {router_card-addr}

Local and Remote Profile Setup reinitialize

Description

Confirm DS0 is set to type data. ds0-addr = {slot:port:channel} of DS0 Example: set a:1:1-24 type data

Cross-connect T1 to router card.

Example: connect a:1:1-24 6:1:1 (router in slot 6)

Disable/enable router proxy. router-addr = {slot:port} of router card. Example: set 6:1 disable.

Set Router LAN as In-Service. Example: set 6:1 up

Telnet to Router card.

router_card-addr = {slot} location of router card

Example: telnet 6 (if earlier than 3.0 release {slot:port} must be used)

To enable any configuration changes, the card must be reinitialized.

4

IP Router - Release 1.8

Image 4
Contents IP Router Supporting Software Version Quick Start Guide Installation Basic SetupPPP Internet Connection Public IP Address Routing Router in SlotRouter in Slot Internet Connection using PPP, NAT/PAT and Firewall Filters Quick Start Guide Internet Connection using NAT Static NAT Addresses Quick Start Guide Back-to-Back with PPP Boulder Router in SlotDenver Router in Slot Back-to-Back with Multi-Link PPP Denver Router in Slot Back-to-Back with Frame Relay Denver Router in Slot