Datalogic Scanning QS2500 manual Scanning Mode, Standby Duration, Same Bar Code Delay Time

Page 20

Scanning

Scanning Mode

Good-read off: The trigger button must be pressed to activate scanning. The light source of the QS2500 stops scanning when there is a successful read or no code is decoded after the standby duration has elapsed.

Momentary: The trigger button acts as a switch. Pressing the button acti- vates scanning and releasing the button stops scanning.

Alternate: The trigger button acts as a toggle switch. Pressing the button activates or stops scanning.

Timeout off: The trigger button must be pressed to activate scanning, and the QS2500 stops scanning when no code is decoded after the standby duration has elapsed.

Continue: The QS2500 always keeps reading, and it does not matter whether the trigger button is pressed or the standby duration has elapsed. Select this mode for use in Stand Mode.

Test only: The QS2500 always keeps a constant reading, and same-label reading is allowed without double confirmation. The feature can test the performance of the QS2500 for reading speed and sensitivity.

Standby Duration

A timeout duration of 1 to 99 seconds can be set. It is effective only when the CCD scanning mode is operated in timeout-off mode and good-read off mode.

Same Bar Code Delay Time

If the bar code has been scanned twice, then only the first bar code will be accepted.

16

QS2500

Image 20
Contents QuickScan QS2500 Datalogic Scanning, Inc Table of Contents Appendix E Alphanumeric Characters Installation Keyboard WedgeWand Emulation RS-232USB Programming the QS2500 Scan the alphanumeric characters located in Appendix EResetting the QS2500 InterfacesOption Bar Code QS2500 Option Option Alphanumeric Default Option Bar Code Alphanumeric RS-232 Advanced Features Response Delay IBM Interface 46XX/USB IBM Options IBM 46xx Code 39 ConversionIBM Host Commands Scanning Mode Same Bar Code Delay TimeScanning Standby DurationDouble Confirm Option Disable Inverted Image Scan Enable Beep/Tone/LED Settings Beep & LED after decode Label Editing includes Prefix/Suffix Option Bar Code Alphanumeric Insert Data Group Disable ID Transmission Enable Symbology Settings UPC-AUCC/EAN UPC-E Truncate Ending FfH Ascii code EAN-13 Disable Checksum Transmission Enable EAN-8 Ascii Code Use Global Min Minimum Code Length Interleaved 2 Use Global Min Code Length Industrial 2 Matrix 2 Ff hexB Codabar ABCD/ABCD Data Checksum UCC/EAN-128 Disable Append Enable Ff hex Ascii Enable two digits Data Digits Variable Checksum1 Optional MSI/Plessey Mini UK/Plessey Alphanumeric Telepen Standard 2 Disable Enable Code 16K Ff hex Italian PharmaCode RSS Expanded RSS Limited RSS-14 Appendix Default Settings Checksum Code Code TypeAppendix B Bar Code Samples EAN-8Matrix 2 Codabar Code Italian PharmaCode RSS Expanded RSS Limited RSS-14 Appendix C Ascii Codes Example Ascii a = Appendix D Parameter Setting List Start Program Standard Parameter Setting ListAppendix E Alphanumeric Characters QS2500 Page Italy