Edimax Technology BR-6004 user manual Setup of WAN connections for this product, Power on

Page 9

Figure 2-3 Setup of LAN connections for this product.

2.Setup WAN connection: prepare an Ethernet cable for connecting this product to your cable/xDSL modem or Ethernet backbone. Figure 2-4 illustrates the WAN connection.

Figure 2-4 Setup of WAN connections for this product.

3.Power on:

Connecting the power cord to power inlet and turning the power switch on, this product will automatically enter the self-test phase. When it is in the self-test phase, the indicators Ready and COM will be lighted ON for about 5 seconds, and then Ready and COM will be flashed 3 times to indicate that the self-test operation has

-8-

Image 9

Contents Broadband Router Trademarks CopyrightCE Declaration of Conformity FCC Interference StatementTable of Contents Introduction Functions and FeaturesPacking List 耟Access Control supported耟Virtual Server supported 耟User-Definable Application Sensing TunnelPanel Layout Hardware InstallationFront Panel Rear PanelProcedure for Hardware Installation Installation RequirementsPower on Setup of WAN connections for this productPage Make correct network settings of your computer Network Settings and Software InstallationPage Start-up and Log Configuring IP SharerStatus Toolbox Primary Setup Dynamic IP Address Static IP AddressPPP over Ethernet Dial-up NetworkDhcp Server Virtual Server Special AP Access Control Misc Items Appendix a Console Mode Install TCP/IP protocol into your PC Appendix B TCP/IP Configuration for Windows 95/98Set TCP/IP protocol for working with IP Sharer Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab