Edimax Technology BR-6004 user manual Set TCP/IP protocol for working with IP Sharer

Page 25

5.Select Microsoft item in the manufactures list. And choose TCP/IP in the Network Protocols. Click OK button to return to Network window.

6.The TCP/IP protocol shall be listed in the Network window. Click OK to complete the install procedure and restart your PC to enable the TCP/IP protocol.

B.2 Set TCP/IP protocol for working with IP Sharer

1.Click Start button and choose Settings, then click Control Panel.

-24-

Image 25

Contents Broadband Router Trademarks CopyrightCE Declaration of Conformity FCC Interference StatementTable of Contents Introduction Functions and FeaturesPacking List 耟Access Control supported耟Virtual Server supported 耟User-Definable Application Sensing TunnelPanel Layout Hardware InstallationFront Panel Rear PanelProcedure for Hardware Installation Installation RequirementsPower on Setup of WAN connections for this productPage Make correct network settings of your computer Network Settings and Software InstallationPage Start-up and Log Configuring IP SharerStatus Toolbox Primary Setup Dynamic IP Address Static IP AddressPPP over Ethernet Dial-up NetworkDhcp Server Virtual Server Special AP Access Control Misc Items Appendix a Console Mode Install TCP/IP protocol into your PC Appendix B TCP/IP Configuration for Windows 95/98Set TCP/IP protocol for working with IP Sharer Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab