OPERATING THE SYSTEM
English
Important:
Before you operate the system, complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the various features offered by the system. When the system is switched on for the first time, the demonstration mode will start automatically.
Notes:
–During the demonstration, if you press any source (or
–When the system is switched to standby mode, the demonstration will resume 5 seconds later.
10
To stop the demonstration mode
•Press and hold Ç(on the system only) for 5 seconds when the system is in demonstration mode.
™The demonstration will stop.
™"DEMO OFF" is displayed.
™The system will switch to standby mode.
Note:
–Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again.
To start the demonstration mode
•Press and hold Ç(on the system only) for 5 seconds when the system is in standby mode.
™ The demonstration will begin.
Easy Set
EASY SET allows you to store all available radio stations and RDS stations automatically.
1Press and hold STANDBY ON (on the system only) for 5 seconds when the system is in standby or demonstration mode.
™“EASY SET” will be displayed, and followed by “TUNER” and then “AUTO”.
™EASY SET will start searching for all RDS radio stations with sufficient signal strength and then followed by radio stations on FM, MW and LW band respectively. Weak RDS radio stations may be stored in later presets.
™All available RDS and radio stations with sufficient signal strength will be stored. Up to 40 presets may be stored.
2The system will proceed to set the RDS time automatically with the stored RDS
preset station.
•If no RDS station is available in the first preset station, the program will exit automatically.
™After a radio station is found, “EASY SET” will be displayed and followed by “TIME”
•When searching RDS time;
™“SEARCH RDS TIME” will be displayed.
™When RDS time is read, “RDS TIME” will be displayed. The current time will be displayed for 2 seconds and stored automatically.
Notes:
–EASY SET will start with the RDS station, if there are still presets available, it will continue to store the FM, MW and LW bands respectively.
–When EASY SET is used, all previously stored radio stations will be replaced.
–The last preset radio station or the first available RDS station will appear on the display when EASY SET is completed.
–If RDS station does not transmit RDS time within 90 seconds, the program will exit automatically and the display will show “NO RDS TIME”.
Switching the system ON
•Press CD, TUNER, TAPE or AUX.
You can also switch on the system by pressing any one of the CD DIRECT PLAY buttons.
10 | 12/12/00, 6:33 PM | 3139 116 19381 |