Note:
–For 'EASY SET' feature, please refer to page 10.
Tuning to radio stations
1Press TUNER (BAND) to select TUNER mode.
™“TUNER” will be displayed.
A few seconds later, the current radio frequency will be displayed.
2Press TUNER (BAND) again to select the desired waveband : FM, MW or LW.
3Press àor áfor more than one second, then release.
™The display will show “SEARCH” until a radio station with sufficient signal strength is found.
•Repeat this procedure until the desired station is reached.
•To tune to a weak station, briefly press àor árepeatedly until the display shows the desired frequency and/or when the best reception has been obtained.
Storing Preset Stations
You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display.
Automatic programming
1Press TUNER (BAND).
2Press PROGRAM for more than one second.
™The PROG flag starts flashing and “AUTO” will be displayed.
™The system will search for every available station in the FM waveband first, then search the MW and LW bands respectively.
™All available stations will be stored automatically. The frequency and preset number will be displayed briefly.
™The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used.
™The system will remain tuned to the last stored preset radio station.
Notes:
–You can cancel the automatic
programming by pressing PROGRAM or Ç(on the system only).
–If you want to reserve a section of preset numbers, for example preset numbers 1 to 9, select preset 10 before starting automatic programming, only the preset numbers 10 to 40 will be programmed.
TUNER
Manual programming
1Press TUNER (BAND).
2Press TUNER (BAND) again to select the desired waveband : FM, MW or LW.
3Press PROGRAM for less than one second.
™The PROG flag starts flashing.
™The next available preset number will be displayed for selection.
4Press àor áto tune to the desired frequency.
•If you wish to store the radio station to
another preset number, press 4 or 3 to select the desired preset number.
5Press PROGRAM again.
™The PROG flag disappears and the radio station will be stored.
•Repeat steps 3 – 5 to store other preset radio stations.
Notes:
–When 40 radio stations are stored and you attempt to store another radio station, the display will show "PROGRAM FULL”. If you want to change an existing preset number, repeat steps 3 – 5.
–You can cancel manual programming by pressing Ç(on the system only).
–During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically.
English
15
15 | 12/12/00, 6:33 PM | 3139 116 19381 |