Freedom9 user manual Initial Configuration Via Dhcp Server, FreeView IP 100 Setup Program

4 Configuration

4.1Initial Configuration

The freeView IP 100 is shipped with the network configuration listed in Table 4-1.

Table 4-1: Initial Network Configuration

Note: If the freeView IP 100 cannot find a DHCP server on startup, it will not have an IP address.

The following describes the initial IP configuration that is necessary to access the unit for the first time. Note: Before installation, make a note of the MAC address of the unit before installing the device, it is located on the label on the bottom of the unit.

4.2Initial Configuration Via DHCP Server

By default, the freeView IP 100 will attempt to obtain an IP address from a DHCP server on the network. To determine the IP address obtained via DHCP, either check the list of assigned IP addresses on the DHCP server and find the IP address assigned to the MAC address of the unit, or set the DHCP server to assign a fixed IP address to the MAC address of the device. Consult the manual for the DHCP server for detailed configuration instructions.

Alternatively, the setup tool KVMSetup.exe found on the Installation Disk accompanying the product can also be used to set up the unit.

4.3freeView IP 100 Setup Program

Connect the freeView IP 100 to a computer via local network or USB. Start the setup tool KVMSetup.exe located on the Installation Disk on the computer. The program screen is shown in Figure 4-1.

18