Juniper Networks M120 manual Gigabit Ethernet IQ2 PIC with XFP

10-Gigabit Ethernet IQ2 PIC with XFP

Software features	■	Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
		(RED), weighted random early detection (WRED)
	■ Configurable WAN-PHY mode options:
		■	loopback
		■	mpls
		■	path-trace
		■	trigger
	■ Virtual Router Redundancy Protocol (VRRP) support
	■	Hierarchical shaping
	■ Fine-grained queueing and shaping per logical interface at both ingress and egress
	■ 802.1q virtual LANs (VLANs)
	■ Point-to-Point Protocol over Ethernet (PPPoE) over VLAN (JUNOS Release 8.5 and later.)
	■ VLAN stacking and rewriting
	■ Channels defined by two stacked VLAN tags
	■ Multiple tag protocol identifiers (TPID) support
	■ IP service for nonstandard TPID and stacked VLAN tags
	■ 802.1p rewrite per channel
	■ Flexible mapping of channels and scheduler resources at both ingress and egress
	■	Flexible Ethernet encapsulation
	■ MAC learning, policing, accounting, and filtering
Cables and connectors	■	You can install any transceiver supported by the PIC. For information about installing
		and removing transceivers, see the PIC and Transceiver Installation Instructions.
	■ Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
		■ Duplex LC/PC connector (Rx and Tx)
		■ Optical interface support—See Table 18 on page 72
LEDs	OK LED, one tricolor:
	■ Off—PIC is offline and safe to remove from the router.
	■ Green—PIC is operating normally.
	■ Amber—PIC is initializing.
	■ Red—PIC has an error or failure.

APP LED, one:

■Off—Monitoring application is not running

■Green—Monitoring application is running under acceptable load

■Amber—Monitoring application is overloaded

Link Status LED, one:

■Off—Port is down

■Green—Port is online. Link is established

10-Gigabit Ethernet IQ2 PIC with XFP ■ 71