Juniper Networks M120 manual Software Feature MultiServices

MultiServices PICs

■MultiServices 100: JUNOS 8.2R2 and later (Type 1)

NOTE: This PIC requires the 710-017980 version of the FPC1.

■MultiServices 400: JUNOS 8.2 and later (Type 2)

■MultiServices 500: JUNOS 8.3 and later (Type 3)

Description	■ Supports tunnel services. This feature is included with the PIC and does not require an
		individual license.
	■ Individual licenses must be purchased for additional services.
	■	Power requirement:
		■ Type 1: 0.52 A @ 48 V (25 W)
		■ Type 2: 0.69 A @ 48 V (33 W)
		■ Type 3: 0.83 A @ 48 V (40 W)
Hardware features	■	Active monitoring on:
		■ Type 1: up to 1.6 million flows
		■ Type 2: up to 3.2 million flows
		■ Type 3: up to 3.2 million flows
Software features	■ Support for up to 2000 service sets
	■ Support for MTUs up to 9192 bytes for Gigabit Ethernet and SONET interfaces
	Depending on your JUNOS release and individual licenses, software features for this PIC can
	include the features listed in Table 24 on page 81. For more information about the software
	features available for services PICs, see the JUNOS Services Interfaces Configuration Guide.
LEDs	Status LED, one tricolor:
	■ Off—PIC is offline and it is safe to remove it from the chassis.
	■ Green—PIC is operating normally.
	■ Amber—PIC is initializing.

■ Red—PIC has an error or failure and no further harm can be done by removing it from the chassis.

Application LED, one bicolor:

■Off—Service is not running.

■Green—Service is running under acceptable load.

■Amber—Service is overloaded.

Table 24: MultiServices PICs Software Features Supported on the M120 Router

Software Feature	MultiServices 100	MultiServices 400	MultiServices 500
GRE Key	–	–	–
GRE dont-fragment	–	–	–

MultiServices PICs ■ 81