Juniper Networks M120 manual SONET/SDH OC12c/STM4 PIC

SONET/SDH OC12c/STM4 PIC

SONET/SDH OC12c/STM4 PIC

Software release	■ JUNOS 8.0R2 and later
	NOTE: This PIC is not supported in JUNOS Release 8.1R1.

Description	■	One OC12 port
	■ Power requirement: 0.23 A @ 48 V (10.8 W)
Hardware features	■	Multiplexing and demultiplexing
	■ Rate policing on input
	■ Rate shaping on output
	■ Packet buffering, Layer 2 parsing
Software features	■	SONET/SDH framing
	■	Link aggregation
	■ Alarm and event counting and detection
	■ Dual-router automatic protection switching (APS)
	■ Multiprotocol Label Switching (MPLS) fast reroute
	■	Encapsulations:
		■ High-Level Data Link Control (HDLC)
		■ Frame Relay
		■ Circuit cross-connect (CCC)
		■ Translational cross-connect (TCC)
		■ Point-to-Point Protocol (PPP)
Cables and connectors	■	Duplex SC/PC connector (Rx and Tx)

■ Optical interface support—See Table 28 on page 93

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links, take the PIC offline until you are ready to establish a link to another device. For information about taking a PIC offline, see the request chassis pic offline command in the JUNOS System Basics and Services Command Reference.

SONET/SDH OC12c/STM4 PIC ■ 91