Juniper Networks | NetScreen Release Notes |
|
|
•02655 – The event log timestamp changed to Daylight Savings Time (DST) even though DST was not enabled.
•02642 – After configuring SCREEN setting thresholds on a device using the WebUI or CLI, the get config include <screen_settings> command did not display the configured settings.
•02641 – The PKI IKE memory pool on a device had a memory leak caused by the Security Manager agent.
•02637 – A session allocation with less than 1,000 sessions on a Juniper
•02629 – When running a get config all command and redirecting the output to a file on the TFTP server when the Trust interface as the source, the file was not transferred correctly.
•02627 – The policy move page only displayed the first 20 policies, and therefore you could not move a policy from the initial screen from where you copied the beyond the 20 policies displayed.
•02624 – An
•02621 – When a Ping request is initiated through a VPN tunnel to a MIP configuration on a loopback interface, the ICMP reply through the tunnel did not get translated back to the MIP address.
•02680 – The SNMP name command inappropriately propagated across the NSRP cluster.
•02682 – When using the WebUI to set information on the backup device, the primary SNMP device was inappropriately deleted when using the unset VSD ID 0.
•02606 – A ping packet through a tunnel in an NSRP environment between two Juniper Networks security appliances failed after a failover until you performed a rekey operation.
•02581 – You incorrectly could define the same IP address to multiple loopback interfaces over multiple subnetworks by running the set vrouter
•02578 – A PPPoE
•02552 – Policy authentication with an external authenticating server could run into the same memory corruption when authentication failed and caused the firewall to fail.
ScreenOS | P/N | Page 18 of 42 |