Juniper Networks | NetScreen Release Notes |
| |
W/A: Execute the save command first, before executing the save config from flash to slot1 command.
5.3.3 Known Issues from ScreenOS 5.0.0r7
None.
5.3.4 Known Issues from ScreenOS 5.0.0r6
None.
5.3.5 Known Issues from ScreenOS 5.0.0r5
None.
5.3.6 Known Issues from ScreenOS 5.0.0r4
•38109 – When running 5,000 UDP sessions between two non-ScreenOS 5.0.0 devices and you upgrade one device to ScreenOS 5.0.0UPGR and the other to ScreenOS 5.0.0r4 via ScreenOS 5.0.0UPGR, only 3,000 of the UDP sessions synchronize properly.
•37938 – The Juniper NetScreen-5000 or Juniper NetScreen-500 device sometimes fails after upgrading from an older version of ScreenOS to ScreenOS 5.0.0UPGR.
•37925 – The L2TP tunnel and Telnet utility both do not work on the Juniper NetScreen-5000 or Juniper NetScreen-500 device after you upgrade the device from ScreenOS 4.0.1r4.2 to ScreenOS 5.0.0UPGR.
•37901 – After you upgrade a Juniper NetScreen-5000 or Juniper NetScreen- 500 device from a running ScreenOS 5.0.0UPGR B (backup) to ScreenOS 5.0.0UPGR M (primary), the current session on the device disappears.
•02369 –You could not change the IKE/AUTH user password using the WebUI. The WebUI apparently takes the change but it does NOT change it when the configuration is viewed.
•02297 – The Anti-Virus scanning engine drops connection with some HTTP/ HTTPS sites.
•02207 – The NS Lookup operation completes without first authenticating to a WebAuth policy. The NS Lookup utility resolves unknown hostnames and URLs.
ScreenOS 5.0.0r9-FIPS | P/N 093-1638-000, Rev. A | Page 34 of 42 |