Juniper Networks 500, 5200, 208, 204, 5XT, 5400 manual Juniper Networks NetScreen Release Notes

Juniper Networks NetScreen Release Notes

•03132 – When using Juniper NetScreen-Remote to connect to a Juniper NetScreen-500 dial-up VPN using the WebUI, the IKE Gateway Configuration displays as user instead of user-group.

•03128 – Mistakes occurred with (MIP) Mapped IP translation when a remote shell used a secondary session initiated from the server for redirecting standard error output from the console.

•03095 – If the Juniper NetScreen-5XT autonegotiated its speed and duplex settings with a Cisco 3550, the devices operated properly, but the connection would fail if you manually set 100MBps - Full and 100MBps - Half for both devices.

•03092 – When the device was in transparent mode, it sometimes was unable to download the latest anti-virus signatures.

•03081 – An anti-virus parsing error slowed performance for HTTP sessions.

•03078 – With a very large configuration, when you attempt to save a very large configuration, the device sometimes generated false HA up-down messages incorrectly indicating alternatively that the device disconnected and connected.

•03071 – If the first VIP (Virtual IP) in the VIP list did not have a service defined for it, if you added a service to the second to fourth VIP in the list, the VIP Summary Page displayed no data.

•03068 – When you modified the IKE Phase 1 gateway name using the WebUI, the primary device in an HA pair could not synchronize properly with the backup device so that the backup device received the IKE gateway name.

•03058 – After you successfully updated a device with the latest configuration in Security Manager, and then ran a Delta Configuration Summary operation, the summary still displayed commands indicating that the update did not successfully transfer all settings to the device.

•03054 – The device did not update its ARP table because too many packets queued up for the same ARP entry.

•03042 – The serial interface on the device disappeared after you downgraded from ScreenOS 5.0.0rx to a previous version with the Unlimited Number of Users Version 2 key installed.

•03025 – In certain situations, when a user authenticated using WebAUTH with SecureID, and the user in the Auth table timed out, subsequent attempts to authenticate failed.

•03010 – In certain situations when you ping a Juniper NetScreen-5200-24FE interface, an error condition occurred which sent out fragmented packets.

•02988 – The ALG did not work for a custom-defined rsh (remote shell) service.

ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 9 of 42