IDP 75, 250, 800, and 8200 Installation Guide
| Mounting Using Device Rack Rails | 18 |
| Mounting Using Midmount Brackets | 19 |
| Connecting Power | 20 |
Chapter 4 | Configuring the IDP Sensor | 21 |
| Initial Configuration Options | 21 |
| Simple Configuration | 21 |
| Simple Configuration Settings | 21 |
| Simple Configuration Values | 22 |
| Advanced Configuration | 22 |
| Connecting to the Sensor | 22 |
| Using the Console Serial Port to Configure the Sensor | 22 |
| Using the Management Port to Configure the Sensor | 24 |
| Connecting Directly Using the Management Port | 24 |
| Connecting Remotely Using the Management Port | 25 |
| Simple or Advanced Configuration Using the Management Port | 25 |
| QuickStart Simple Configuration | 26 |
| ACM Advanced Configuration | 26 |
| Connecting Forwarding Interfaces | 28 |
| Verifying Traffic Flow | 28 |
| Connecting the High Availability Port | 28 |
Chapter 5 | Adding the Sensor to NSM | 29 |
| Adding Your Sensor to NSM | 29 |
| Checking the Status of Your Sensor | 33 |
Chapter 6 | Updating Software on the Sensor | 35 |
| Updating IDP Sensor Software Using NSM Firmware Manager | 35 |
| Loading a Sensor Image into NSM | 35 |
| Upgrading Sensor Software | 36 |
| Updating IDP Sensor Software Without NSM | 36 |
| Reimaging the IDP Sensor | 37 |
Chapter 7 | Servicing the Device | 39 |
| Replacing a Power Supply (IDP 800, and 8200 Only) | 39 |
| Remove a Power Supply | 39 |
| Install a Power Supply | 40 |
| Replacing a Hard Drive (IDP 800 and 8200 Only) | 40 |
| Remove a Hard Drive | 40 |
| Install a Hard Drive | 41 |
Chapter 8 | Advanced Configuration | 43 |
| Advanced Deployment Modes | 43 |
| Bridge Mode | 43 |
| Router Mode | 45 |
| 46 | |
| IDP High Availability Deployment Modes | 46 |
Appendix A | Specifications | 47 |
| IDP 75 Technical Specifications | 48 |
| IDP 250 Technical Specifications | 49 |
iv Table of Contents