B&B Electronics TPC-1261H user manual Power, I/O Ports Arrangement, Panel Mounting

1.5Power

•Input Voltage: 18 - 32VDC (the fuse will become an open circuit if the input level exceeds 33 VDC)

•Typical: 24VDC@2.5Amp

1.6I/O Ports Arrangement

The arrangement of the I/O ports is shown in Figure 1.1.

Figure 1.1: I/O Port Arrangement

1.7Panel Mounting

1.There is an adhesive waterproof gasket on the Mg-AL front bezel. Make sure the waterproof gasket is in position before installing TPC-1261H into the panel opening.

2.Install the TPC-1261H into the panel opening.

3.Find the eight clampers and eight long screws in the accessory pack. Hook the clampers to the holes around the four sides of the bezel. Insert the screws into every clamper and fasten them. These screws will push the mounting panel and fix the unit.

4.The suggested mounting panel thickness is less than 6 mm (0.236”).

5 Chapter1