![](/images/new-backgrounds/1193721/19372147x1.webp)
3. Setup and Connections | Vlinx MESR9xx Modbus Gateway |
Reloading Factory Defaults
To reload Factory Defaults, press and hold the Mode switch for more than 10 seconds. The LED indicators respond as follows:
1.The Ready LED blinks three times per second while the button is being pressed.
2.The Modbus gateway is in Factory Default Mode when:
•On the MESR901: Port 1 LED and the Ready LED are both On.
•On MESR902x models: Port 1 LED and the Port 2 LED are both On.
The Modbus gateway reloads all factory default configuration parameters.
3. The LEDs go back to their normal states when the device resumes normal operation.
Note: Factor default parameters are listed in Appendix A
Page 20 | Manual Documentation Number |
| |
|