Buffalo Technology WLA-G54C, WRB-G54K manual Perform the next step for Wireless Router Setup only

Perform the next step for Wired (Recommended) Router Setup only :

◗Locate the provided Ethernet cable and connect one end to any one of the four numbered SWITCH ports located on the back of the router. Connect the other end of this cable to the properly installed Ethernet (NIC) port on the PC you are using for initial setup (Refer to Figure 1).

Perform the next step for both Wireless AND Wired Router Setup:

◗Locate Power adapter for the Wireless Router and Plug in to the DC-IN port on the back of the router and the other end to a wall outlet. (See Figure 1 for location of DC-IN Port).

Perform the next step for Wireless Router Setup only:

■NOTE: You will need the SSID of your router to properly connect your wireless adapter to your router. The default SSID for your Precon- figured Buffalo Router is “Buffalo” (case sensitive).

◗Refer to your Wireless Ethernet adapter Manufacture’s documentation for proper setup of your Wireless adapter for your appropriate Operating System and connect to the router.

The Remaining Steps apply to both Wired and Wireless Setup:

◗Power up you Cable or DSL Modem

◗Power up your computer that you are using to configure the Wireless Router.

4